14-007-00088 Large Auger | Spiral Feeder Screw for XAG RevoCast 4 Spreading System, Replacement Spare Part for Agricultural Drone

Large Auger | SKU: 14-007-00088

• Part Number: 14-007-00088, RevoCast 4 Large Auger

• Wider spiral pitch for high-volume material conveying

• High-strength wear-resistant material, anti-corrosion against chemical fertilizer

• Stable continuous feeding, effectively reduce material blockage

• Precise dimensional matching, direct replacement without modification

• Quick disassembly for daily cleaning and maintenance

✅ Recommended Materials

Urea, compound fertilizer, large-size granular fertilizer, coarse feed pellets.

✅ Compatibility

Fit XAG agricultural drones equipped with RevoCast 4 spreading system:P60 2024, P150 2024, P60 Pro 2025, P150 Pro 2025

• Large Auger: High flow rate, mainly for granular fertilizer (urea, compound fertilizer)

• Medium Auger: For rice seeds, grass seeds, medium granules

• Small Auger: For tiny seeds and fine powder

• Package Includes: 1 × Large Auger (14-007-00088)

• Large Auger: High flow rate, mainly for granular fertilizer (urea, compound fertilizer)

• Medium Auger: For rice seeds, grass seeds, medium granules

• Small Auger: For tiny seeds and fine powder

Bullet Points

• OEM Replacement Part：SKU 14-007-00088 Large Auger for XAG RevoCast 4

• Designed for RevoCast 4 spreader system of XAG agricultural drone

• High conveying capacity, perfect for large-area fertilization

• Wear-resistant construction, long service life under continuous farm operation

• Smooth & consistent material delivery, lower jamming risk

• Direct plug-and-play installation, no extra machining required

• Easy to detach and clean after each operation

Q1: What is the part number of this auger?

Q2: Which drone models are compatible?

Q3: What materials suit this large auger?

Q4: Can I use this auger on RevoCast 3 or RevoCast 6 spreader?

Q5: Do I need modification during installation?

Q6: What’s included in the package?

Q7: When should I replace the auger?

User Guide

1. Power off the drone and cut off spreader power supply before replacement.

2. Open the spreader housing, remove fixing screws of the old auger assembly.

3. Take out the worn auger, align the 14-007-00088 large auger with drive shaft.

4. Tighten screws evenly; avoid over-tightening to prevent thread damage.

5. Rotate auger manually to check no friction or stuck condition.

6. Run empty test before formal spreading operation.

Maintenance Tips

1. Clean residual fertilizer and debris after every operation to avoid corrosion and caking.

2. Remove wet, agglomerated materials to reduce auger abrasion.

3. Check screw tightness regularly; replace immediately if spiral blade shows obvious wear or deformation.

4. Store in dry environment during long idle periods.

Important Notice

• This auger only fits RevoCast 4 system, not compatible with RevoCast 3 / RevoCast 6.

• Not recommended for ultra-fine powder or extra-small seeds.